FIELD INSTALLATION - RECLAIM BELT
Northwest Indiana Power Plant
Crews out installing a 36" x 500 ft.
COAL RECLAIM BELT
CONVEYOR BELT DIVISION
Friday, September 6, 2019
Wednesday, June 19, 2019
101st National Slag Association Annual Meeting
Sept. 16-20 Pensacola, Florida
Gary Hanson ( the Belt Doctor ) will be presenting a Technical Paper at the Annual Slag Association Meeting in Pensacola, Florida during their 101st Annual Meeting and Conference. Technical Paper subject: " Matching your Operations and Process Expectations with Conveyor Belt Specification and Performance.
#1 Common Mistake in Conveyor Belt Procurement - " all belts look alike, its simply a commodity buy .... the only variable is Price"
It is going to be a great subject to discuss and focus on, as selection and application is just as important as price ... and it directly affects your " TOTAL COST OF OWNERSHIP"!
Monday, January 28, 2019
Pipe Belt Job Complete .... 18, 264 ft.
Pipe Belt- How to move Coal from the Port to the Plant without spillage or dust // Project Completed:
Working in Conjunction with our Field Service Authorized Splice and Mechanical Partner -the excellent group from American Mechanical Services based out of Chicago- we embarked on a Joint Project to supply and install 18,264 ft. of Steel Cable Pipe Conveyor Belt for a Power Generation facility.
Logistically, it was a challenge - (13) rolls -43,500# each - had to be shipped by Container to the Port Facility, unloaded and then positioned for the physically tough job of pulling the old Pipe Belt off, the new Pipe Belt on one roll at a time and vulcanizing each connection to end up with about a 3.5 mile continuous Pipe Belt Delivery System.
This is the Port Unloading System
( unloads Coal and then thru a few transfer systems it ends up on the Pipe Belt
for the "continuous closed" transport to the Generating Plant )
Rolls were shipped on special cassette configured rolls to allow for container height restrictions
CONVEYOR BELT
HAMAHEAT - the Leader in Heat Resistant Conveyor Belt
> Handles loads up to 750 Degrees F
> Superior Abrasion Resistance
> Reliable Vulcanized Splices
> Manufactured to Width with Molded Edges
> Lower Cost Per Tonnage Performance
Yokohama has dedicated years of research to delivery key breakthroughs in heat tolerance, abrasion resistance and splice adhesion when it comes to the development of their High Heat application Conveyor Belt Technology.
HAMAHEAT Conveyor Belts
> Resists hardening and cracking
> Maintain cover tensile strength 5 times greater
than the two nearest competitors
> Improved cover performance under extreme heat
conditions extends life and minimizes carry back
> Premature belt failure due to cracking and blistering
is greatly diminished with this high end technology
> Resists cupping and curling which leads to better
tracking, and molded edges reduce delamination
and the typical loss in edge integrity
____________________________________________
Call the Belt Doctor : 269-830-6870
To Check on Availability and Pricing
www.beltdoctor.com
ghanson@advancedrubbertechnologies.com
ghanson@americanchemtech.com
________________________________________________
Advanced Rubber Technologies
CONVEYOR BELT DIVISION
Division of American Chemical Technologies
__________________________________________________
Gary Hanson - VP/ General Manager Conveyor Belt Division
269-830-6870
Ross Kovanda - VP / American Chemical Technologies
248-521-3351
rkovanda@americanchemtech.com
Conveyor Belt Warehouse > Gary Indiana
Corporate Office > Fowlerville , Michigan
800-938-0101
www.americanchemtech.com
Subscribe to:
Posts (Atom)